So let me understand what you did with genisys.you installed the software on your computer (what version windows) and once it updated now it will not power on, correct? Does it make a beep or anything? Usually no power up is due to dead battery so be sure battery is up. I have the smart inserts cable, as the "smart cable" only works with 3.0 and up. There is a 32MB card inside, and a 512MB outside. The more I think about it, I should have just bought the TSI/VSI cartridges for my SnapOn.Īny help you could provide with the Genisys would be great. I bought the Genisys because I was looking for a better tool that I could also update. I also have a SnapOn MT2500, but the cartridges aren't current enough to have that option. I was told I need to set my fuel sync to +6 or so for use with the cam.Īs it is now, the Jeep is throwing a B1 lean code. I rebuilt the motor a few months ago, and built it with a mild Comp cam. No display, no noises.Īnyway, I'm working on my 96 Jeep Grand Cherokee, 4.0L, 42RE, 4WD. I could see if I could get it to at least power up, I could recover it or something, but the tool now does nothing. OTC says no repair on these, so I guess I am stuck with an expensive piece of plastic. I don't have the wall wart for it.) Power was provided by my 12v power supply for my amateur radio. I'm on external power (through the cable w/ the lighter adapter. Went to turn it on, and now the damn thing won't even power up. Came back to it later, and it SId it was done, and the tool was powered off. It found updates, and took 3 hours to do it. I installed it on my computer, and then ran the update. Well, I contacted the seller, and he had the CD, and sent it to me.
0 kommentar(er)
